Tips for using a compression air compressor mainly include the following aspects:
Preparation before starting: Before starting the compression air compressor, it is necessary to check whether all parts of the equipment are intact, especially the transmission part and the lubrication system. Ensure that the air inlet and exhaust ports of the equipment are unobstructed to avoid excessive resistance during the compression process. In addition, it is necessary to check whether the wiring of the electrical system is firm and reliable, and whether the safety protection device is intact.
Startup and operation: After completing the pre-startup inspection, turn on the power switch, press the start button, observe the indicator lights and instrument readings on the control panel, and ensure that all parameters are within the normal range. During the operation of the equipment, key indicators such as temperature and pressure should be checked regularly, and adjusted in time to maintain the best working condition. At the same time, pay attention to the sound of the equipment running. Any abnormal sound may be a precursor to a fault, and the machine should be stopped for inspection in time.
Maintenance after shutdown: After pressing the stop button, the power cannot be cut off immediately. Wait until the equipment naturally decelerates to complete stillness, close the relevant valves and auxiliary equipment, and clean up the surrounding debris and dust. Record equipment operation data and maintenance details to provide key guidance for subsequent maintenance.
Daily maintenance: Regularly replace lubricating oil, replace oil filter and lubricating oil in time according to the manufacturer's recommended cycle, and keep the interior clean. Clean the cooling system, frequently check whether the cooling fan is blocked, and remove dust accumulated on the surface of the radiator. Regularly check whether the joints of each component are loose, and tighten the screws if necessary to prevent air leakage.
Safety use tips:
Cooling water supply: When the air compressor is started, the cooling water supply is very important. If the cooling water is not supplied in time, the air compressor must be stopped immediately.
Safety valve and pressure gauge: The air compressor must be installed with a verified safety valve and pressure gauge to avoid overpressure operation.
Pressure reducer: When introducing compressed air into a low-pressure system, a pressure reducer must be installed.
Environmental selection: The air compressor should be located in a cool, clean, well-ventilated place, away from dusty, flammable gases, corrosive gases, and water vapor.
Airflow direction: When using compressed air safely, the airflow direction cannot be towards people.
